cluth spring torque! HELP!

[xNOILABOYx]

ok, i did everything by my CLYMER manual installed the whole kit,friction pads,metals,and springs i torqued the screws to 9ft lbs. filled her w/ oil twice. like my dealer told me, but now after 10 mins of riding when i clutch it wants to pull so much that i have to start it in neutral and when i put it in gear holding the clutch in, it jumps like the cluth wont engage

i talked to my cousin and he says ur supposed to torque to 7ft.lbs.
will this fix my prob?

[AtvMxRider]

Try adjusting the clutch. All you have to do is hand tighten the screws. The springs keep them from backing out.

[cals400ex]

yeah, how much play do you have in the lever?

[Braff1]

If you are using the stock basket and hub you need to be careful since they are cast aluminum. They will not take much to break. 7 ft/lbs is the torque for them. But if you have it all togather I say you need to adjust the clutch lever to fix your problem.

[fastkid400]

thats your problem, mine was doing it too. just need to adjust ur cables.:)

[xNOILABOYx]

adjusted my cables as far as tehy can go and it still grabs,the only diff is the clutch is hard as hell to pull now

[cals400ex]

it will tell you in teh manual how much play needs to be in the lever. make sure there is a little bit.