How to put on nacs graphics

[400-416EX]

I got some nacs graphics for my 400ex and I am not sure how to put them on. Please help me. I wish they were one piece

[fastblaster2002]

fill a spray bottle with soap and water...only a little and spritz it where your graphics are gonna go...then place them on and slide them around until you get them in the right place

[Johnny & Monica]

That or 409 an have a hair drier close by with a flat plastic puddy knife to press the bubbles out an sread it evenly good luck:D

[400-416EX]

Thanks guys. I put them on. Check it out in the body section under before and after, and tell me how I did.

[QuAdEr 317]

why u need the hair dryer?

[JRDrider22]

to dry it. so your graphic dont keep moving around after you installed them