Can it get any worse?

[HondaRebel]

Ok ....i got my nerfs today...got them ready to put on ... went to take the pegs out...and snap one of the peg bolts sanpped in half inside...what to do?

[1badex]

what worked for me is to drill a hole as center as you can and get this peice called a (easy out) you can get them at sears or any department store. it sort of looks like a drill bit. get that and hit it in with a hammer, and then wrench it out. as you turn it to come out it grips the inside of the bolt and should screw right out.hope this helps.

[gratzracing24]

I have a bolt stripped which holds the brake caliper on and a guy said its common for this on 300exs...any1 else have this problem? any suggestions? btw sry for posting in ur thread but ur on the same subject

[xNOILABOYx]

dremel a line through it and use a screwdriver to screw it out

[Butters]

Originally posted by 1badex
what worked for me is to drill a hole as center as you can and get this peice called a (easy out) you can get them at sears or any department store. it sort of looks like a drill bit. get that and hit it in with a hammer, and then wrench it out. as you turn it to come out it grips the inside of the bolt and should screw right out.hope this helps.

[250rider]

redrill and tap it or drill and heli coil it.

[Cole Trane]

Or just take it to a muffler shop or something and have them drill it out. Might cost a few bucks, but you don't have to do it.

[HondaRebel]

Took it to a shop and they did it

[gratzracing24]

If you dont mind me asking...how much was it?

[HondaRebel]

50 bucks to take them out and put a heli coil in

[gratzracing24]

OK thanks

[Pappy]

Originally posted by HondaRebel
50 bucks to take them out and put a heli coil in

:eek:

[BIGBLOCKBILL]

Have someone weld a nut on the stub of the bolt. The heat will help loosen it and should come right out with a wrench.