clutch and brake problems

[ready2rip]

I'm having a problem with rear brake pads being to tight to go on around rotor? I checked and cleaned caliper-seems ok-any hints?

Also putting clutch back together and am running into a problem with not getting the right adjustment out of it. The clutch lever is either too hard to pull in or way to much slack? I would really appreciate any kind of input. Thanks!

first thing I would do is replace your clutch cable with another stock one...& your breaks...you have to clamp down on the piston to go all the way back down & then slide your pads on...there should be room then

[Ty's400]

It is recommended that there be 1/8" slack in the clutch. Try adjusting it until you reach this and see if that helps any.