oriclez
07-24-2004, 10:34 AM
Well, I went to start my quad, and I heard a Pop. So a few days later I open up the left crank case to check the one way clutch. The one way starter got moved foward to where the drive gear on the starter wouldn't spin it, so I pushed everything back. I figured before I installed the gaskets, ect I would just put the left case cover on with screws along with the starter cover and its gears. So at this point I hooked back up the electrical and went to start it and it did nothing. Would the reverse lever have anything to do with this? Since I know you cant start the quad in reverse, but I never adjusted the reverse lever other than taking it off and putting it back on. I screwed around with adjusting the lever but it still wouldn't stop. I don't have a headlight connected right now, so im not sure if its getting any power.