bronco 4 low problem

[Mr.250X]

I have an 1988 ford Bronco,My dad and me put a 7inch lift and then I bought 32inch all terrian tires.O course we had to extend the linkege for the trans. Then now I put it into 4high then into netural and pushed Low range and nothing happens. It goes into 4 high just great and the trans shifts good and everything looks good and soild.Thanks

:huh

[jay's 300]

Sounds like you shifter's not moving all the way into 4 lo position, since it is working in 4 hi. Just a guess :confused:

[Honda4trax250x]

theres already a thread you made about this a little further down the page......:huh :confused: :huh

[Cody_300ex]

Originally posted by Honda4trax250x
theres already a thread you made about this a little further down the page......:huh :confused: :huh


yea i was wondering the same thing! :confused:

[Mr.250X]

Well I posted it again because I was waiting for a reply.I came back to the computer and my thread was half down the page with no replys.:eek2:

[Honda4trax250x]

Originally posted by Mr.250X
Well I posted it again because I was waiting for a reply.I came back to the computer and my thread was half down the page with no replys.:eek2:

so just post something on the thread nextime and it will go back to the top, this is the reason for posts just saying "Bump";)

[diesel-mech]

If you added a body lift the shift lever is probably hitting the body. you will have to extend the linkage to the t-case and adjust it properly, In some cases you have to physically bend the shifter lever itself, Heat it with a torche and shift it into high range them push it until the shifter bends slightly. Don't catch anything on fire! You want to heat it close to the pivot point. after it cools it should shift easily into all ranges.
Good luck

By the way why 32" tires? they will fit on it stock, With 7" of lift you can fit 36" tires Just wondering:confused: