s-10 wheel bearings

[bradley300]

any body ever replace them? just wondering if its difficult to do om my 01, thanks for the replies

[cdalejef]

Front pretty easy, rear.....forget it!

[MY450R]

SORRY BUT YOU'LL GET PRACTICE REPLACING THEM CAUSE THEY WILL PROB GO A COUPLE OF TIMES S10 AND BLAZERS ARE KNOWN FOR IT VERY EASY TO REPLACE HOWEVER
USUALLY ONJLY THE FRONTS GO WHICH IS A GOOD THING CASE THE REARS ARE A LITTLE TRICKY

[KJ#14]

The bad news is you can not just replace the bearing. You have to replace the hub ***'y with the ABS sensor built into it.:o The only problem I had was getting the hub ***'y off the spline. It took a puller and a little "hammer time" to break it free.

Good luck to ya:)

[bradley300]

thanks, might gonna try to give it a shot this week or next

[1988R]

Originally posted by KJ#14
The bad news is you can not just replace the bearing. You have to replace the hub ***'y with the ABS sensor built into it.:o The only problem I had was getting the hub ***'y off the spline. It took a puller and a little "hammer time" to break it free.

Good luck to ya:)

I assume you are talking about the rear becaus in the front you can replace just the bearings. Atleast on a 96' but I know s-10's never changed much