how much usually is a bore job

[badrider]

i found a piston and rings on ebay and they are.They are 1.00 over size. and around how much would it cost to get a head bored to fit that size? i have a kawasaki KLT 110 1984 thanks.

[3x440ex]

my shop charges $50 to up it .40 over...

[quadkrazy400ex]

30-40 bucks (for me anyways) for a bore

[hondarider2006]

My shop charged me $55 for my 416 bore. They said that its $55 for a standard bore, and $75 if they have to re-sleave the cylinder. I am getting mine bored, and a 3-angle valve job for $135.

[Giz400ex]

Should be around $40

[TC426EX]

40-50 bucks for JUST the bore...

[brif]

About $30-$40 around here although if you have a plated cylinder it will have to be plated again afterwards. Then can you say Ka-ching........