Durablue Sprocket Hub

[CEET400ex]

I have a Durablue Axle with the durablue sprocket hub and I was wondering, if anyone else has this setup, how far the hub part that goes into the carrier dust seal sticks out. I tightened my axle nut all the way and there still looks to be about 1/8" sticking out of the dust seal but it looks like it seals good. Im just wondering if this is normal so my bearings wont wear prematurely.Thanks ahead of time.CEET

[CEET400ex]

Also if anyone ahs this setup can you post a pic of the rear end b/c i wanna check my sprocket alignment b/c it looks like my chain is at a bit of an angle. Oh yeah...I' running the stock carrier& swinger if that helps.

[CEET400ex]

TTT