Log in

View Full Version : 38 airstriker carb question



crashsmith
06-12-2004, 11:11 AM
I have just received my 38mm airstriker carb. The inlet manifold (insulator) is still stock for the 34mm. Do I use the stock maniflod or need to replace it with a CR manifold? If so which one?
Thanx

powerslider
06-12-2004, 08:18 PM
You can use the stock one, heat it with a hair dryer to make it more flexable...

Roostin250R
06-14-2004, 07:41 AM
You can also throw it in a pan of boiling water for a few minutes to soften it up.

Sinsai
06-17-2004, 06:08 PM
I just put a small amount of WD40 on the inside of the boot where the carb touches, works good!

speedfreaksguy
06-19-2004, 10:55 AM
Mine was always a pain in the ***** to put on. Heat it up or buy a bigger boot.

rummerd
07-05-2004, 08:21 PM
CR intake and reed setup works very nicely, it is already set up for the 38 mm AS. I got mine from ESR when I put my 310 kit on. It ran like a champ. I think it is a 96 or something close. ESR was very reasonable on the price at the time. I had to use a spacer from ESR as well to keep the airbox.