1988 250r for sale

[wwclea01]

2500 obo. Needs new crank, cylinder or re-sleeve on the cylinder I have, piston and rings, and new clutch center. Motor overheated due to a small pin hole in the radiator that I did not notice and tore these parts up. Bike comes as seen without hand guards. It also needs a new swingarm. I just replaced the chain and sprockets and and put new bearings in the dual row carrier. It has works triple rate shocks with rezzies and maier plastic, paul turner pipe and silencer and razr2 on the rear and holeshots on the front.May trade for a newer 125 dirt bikehttp://www.imagestation.com/picture/sraid105/pcd60efd0a903fbbfcd71734c656c0a60/f9759ace.jpg

[wwclea01]

ttt

[SSracingNY]

where you located?

[Hondarider250x]

You have got to make it a lower price Cause you are basically rebuilding the whole thing which about 2 grand How bout you go lower and We will talk? Where are you located? And do you have anymore pics?

[wwclea01]

Im located in terre haute IN. How will it be 2000. You can find used aftermarket swingarms for 250 to 300. A crank is about 200 and a sleeve for the cylinder is about 100 plus the piston and rings and all gaskets. It wouldnt be over a 1000 to do everything to it. It also will come with a service manual.

[wwclea01]

Remember I have or best offer. Il tell you now though, the price will not be much lower than it is now because I have a lot of money in it.

[Hondarider250x]

Any more pics like closeups?

[wwclea01]

heres what I have a little dirty. The shock springs could use a powdercoat job. http://www.imagestation.com/album/?id=4287007399

[CHAR250R]

If you decide to part it out, give me first crack at the frame. Charlie.

[fastkid400]

Yeah if u want to sell the motor, I might be intrested, ill pick it up, im in Northern Indiana.

[wwclea01]

ttt

[CHAR250R]

Thinking about parting it out, yet?:D