sprocket change front or rear

[motoman00440es]

I would like to get a little more top end with out loosing a lot of bottom end right now I'm running 15/38 thanks for any help:confused:

[roostin_dale]

the higher the ratio, the more top end you have...

Lower the ratio, more low end torque...:)

[khen]

Originally posted by roostin_dale
the higher the ratio, the more top end you have...

Lower the ratio, more low end torque...:)
exactly! only opposite :p

[TC426EX]

If you want more top end just go a little smaller in the back like to a 37 or 36....

[roostin_dale]

Originally posted by khen
exactly! only opposite :p

DOH! my bad..lol

[ain't ready]

If you have a 440, you should be able to run a 16 tooth front and get more top end in each gear. I recently did and my motor is stock with rejet and pipe. I'm also running 18" rear for mx.
If you try the 16 you'll have to grind your case saver or buy an aftermarket to fit.
JB