lt250r idle?

[mxlt250r]

Have any of you guys on here gotten your lt to idle? On mine it wont. It runs good and I have cleand the carb and eveything. The only thing I can think to is get a new carb. Thanks for the help:)

[LTandRaptorider]

Yes, mine would idle with either the stock carb, or the 38mm Keihin. Is your idle too low? Need a little more info. Make sure the carb is clean, jetted correctly, air screw set, clean air filter, no tears in the boot...

[mxlt250r]

It has a new clamp on air filter from k&n its clean to and a fmf pipe on a 240 main.It does not idle at all.I can rev it up and it will idle real high for a few seconds and then just stop idleing and want to die.I have played with the air screw throttle cable and their are no tears in boot.

[LTandRaptorider]

Do you have the stock 34mm Mikuni carb on it? I can't remember what main I ran with the stock carb, but the pilot is what will affect the idle. You may need to go up a size or 2 on the pilot jet, since you have the clamp on filter. Set the air screw at about 1.5-2 turns out.

[LT250Racer609]

its your throttle cable...get a new one...it will be solved...

i had the same problem with my 89...i musta took the carb off. 5 times before i figured out that it was my throttle cable

[LT250Racer609]

or since you put the K and N on...did you adjust the air flow mixture screw?? that could also be your problem