Hiper Wheels

[roughrider01]

Im puting on a set of rear hipers right now and wondering how hard to torque down the screws for the locking ring. Anyone know the torque specs?

[roughrider01]

Nm i called hiper, no more then 10 ft. lbs.

[eddings]

The torque isn't much but if you don't tighten them down enough they will leak. When properly tightened they hold air for months.

[KILLAQuad]

The instructions say 10 - 12 ft/lbs..... i say just get a 1/4" socket and ratchet and tighten them down till you start to hurt your wrist.......... thats what i did and i was inbetween 10-12 when i went back and checked them later (3 months) with a torque wrench.......

They have never leaked on me ........and they are close to the best wheels out there......;)

[roughrider01]

I pretty much just tightened them until there wasnt a gap between the ring and the wheel. If they start to leek alittle bit ill tighten them some more because i know i didnt even tighten them to 10 ft/lbs.

Thanks.