How To Properly Break in a Trinity Motor?

[MichaelS693]

How do i need to properly break in a 240 blaster that has new sleeve, piston, head mod, port polish, ect.:confused:

[RMX500]

same as a regular new motor. don't idle lots, and go through all your gears without going too hard. after a tank of gas, step it up a bit. after that tank you're good to go.

[MichaelS693]

well they used to have the way on their web site how to do it an i wanna do it right without screwin it up

[UglyMotha™]

break it in the way your goin to ride it

[EvilJester400EX]

Heat cycle the bike a few times, crank it, let it idle, then shut it off. Repeat this about 10 times, then get on it, ride it for 10 minutes easy for 3 times.. then open it up. It's what I did on my YFZ and EX, neither have had problems.