How to fix bent Bumpers

[seatec]

I so far have bent the "ears" of two bumpers so far on my quad. One Ac Racing and One PRM Desert bumper. both times i bent the left side to wards the rear a little. What would be a good way of bending them back without fatiguing the Aluminum to much?
THanx

[thomez]

Sorry, gotta say it.



BFH!!!! :devil:

[seatec]

I might be a bit dense but what does "BFH" mean?

[300exOH]

Big Friggin Hammer= BFH

[seatec]

Originally posted by 300exOH
Big Friggin Hammer= BFH


Ah, thanx

BFH is the ticket. I took my desert bumper off. Layed it face down on the ground and hit it with a 16 lb sledge a few times and wallaa. Back to normal..:D

[seatec]

i like your subtleness Rico. lol. So let it be written so let it be done. thanx for the tip

[nacs400ex]

Wrap a chain around your axle and attach it to a wall or car or something heavy. Then attach a come-along onto your bumper where the bend is. Then just keep making it tighter until your bend is fixed. Did this before on my quad, came out perfect. I did this over a hammer, because I was afraid of marking up my bumper.

[ridesa02400EX]

heat it up a little and bend it back with some pliers

[dingo]

Place a 2X6 on the ground place the bumper on top of the 2x6 take your vehicle and drive on top of it. then bend in it back. kinda like a press.

Or go to a machine shop see if they will press it back