joshyz125
05-03-2004, 09:50 AM
I was wondering if any body would be interested in a 1978 chevy 1/2 ton 4x4 truck. This truck has 17 Inches of lift. 10 inch suspension, and a 7 inchcustom frame lift. It has a 350. 4-speed, and a 205 transfer case, which is the good gear to gear transfer. 22 gallon fuel cell in the bed, and a gel batterie that is also mounted in the bed. 2 electric fans 1 pull one push.
The bed has a steel diamond plate floor, very heavy duty. It also has a roll bar.
I put a hitch receiver on it.
I have put a drop drag link, raised steering arm, and a steering block on this truck. I took the rag joint out of the steering column and replaced it with a small u-joint.
This truck needs both front and rear drive shafts, i have them but they need to be lengthened.
I've lost interest in working on this truck, plus i don't have them money to finish.
The bed has a steel diamond plate floor, very heavy duty. It also has a roll bar.
I put a hitch receiver on it.
I have put a drop drag link, raised steering arm, and a steering block on this truck. I took the rag joint out of the steering column and replaced it with a small u-joint.
This truck needs both front and rear drive shafts, i have them but they need to be lengthened.
I've lost interest in working on this truck, plus i don't have them money to finish.