Fuel overflow

[jmoney45]

I put an hrc endcap on, took my lid off, and put a 185 main jet in. I left my pilot and air screw where they were. It runs great, a small hesitation off bottom but I think that's cuz it wasn't all warmed up. Seemed to go away after warming up.

One thing I noticed was fuel was dripping out of the carb overflow tube (the one that snakes down near the front sprocket), after I stopped riding. Never did this before. Could the bigger main cause this?

[jmoney45]

And also what is the little screw next to the idle adjuster? I initially thought it was the air screw but don't think that's it.

[rap169]

if its the little screw on the right side near the bottom, its the fuel valve screw. If you loosen it feul will run out the overflow tube and drain the bowl . It should be tight. check that.

[rap169]

sorry i meant left side

[jmoney45]

I think that's it. I was playing with it. I'll check tomorrow to make sure it's tight. Thanks :D