hondafreestyler
04-22-2004, 08:07 PM
Has anyone had trouble with the stock 400ex hubs going onto the rpm dominator axle? ... it seems a little tight ... I didn't hit it or anything just pushed a little and it didn't want to go on ... should I maybe grease the splines really well?
Just wanted to know if anyone else had this problem ...
And I am running Burgard +2 a-arms ... do you just use the stock tie-rod ends? ... should I go with aftermarket? ... if so whice ones?
And ... this will sound dumb ... :rolleyes: but .... the stock spindles (steering knuckle) ... are marking L (left) and R (right) ...
Are they marking these looking at the quad head on? ... or are they marking these as your sitting on your quad?
Thanks
-Mike
Just wanted to know if anyone else had this problem ...
And I am running Burgard +2 a-arms ... do you just use the stock tie-rod ends? ... should I go with aftermarket? ... if so whice ones?
And ... this will sound dumb ... :rolleyes: but .... the stock spindles (steering knuckle) ... are marking L (left) and R (right) ...
Are they marking these looking at the quad head on? ... or are they marking these as your sitting on your quad?
Thanks
-Mike