View Full Version : Stock Clutch Assembly
James Parent
04-15-2004, 07:13 PM
I'm going to get a new clutch lever+perce for my 2003 honda 400ex.. what do i do with the two wires that are going into the stock clutch assembly??
And can i just get rid of the light switches and starter button that are next to the stock clutch lever?
Anyone have pictures of where you put a new starter button? Thank you a lot
james
K_Fulk
04-15-2004, 10:47 PM
Just connect the two wires in the perch together. Just make sure you pull the clutch in when you start it in gear.
cut the little box out & tie the two wires together & tape them up...this allows you to start in any gear but whach out...the four wheeler will turn without the clutch pulled in now if you hit the starter button & it will cause it to jump forward
James Parent
04-16-2004, 07:37 AM
what about that whole big black part with the light switches, kill switch and starter button? Can i just take all of that off and put a starter button somewhere else?
james
4wheelboy
04-16-2004, 09:50 AM
most people use a dirt bike kill switch but i dont know how they wire that in:confused:
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.