Stock Clutch Assembly

[James Parent]

I'm going to get a new clutch lever+perce for my 2003 honda 400ex.. what do i do with the two wires that are going into the stock clutch assembly??

And can i just get rid of the light switches and starter button that are next to the stock clutch lever?

Anyone have pictures of where you put a new starter button? Thank you a lot
james

[K_Fulk]

Just connect the two wires in the perch together. Just make sure you pull the clutch in when you start it in gear.

cut the little box out & tie the two wires together & tape them up...this allows you to start in any gear but whach out...the four wheeler will turn without the clutch pulled in now if you hit the starter button & it will cause it to jump forward

[James Parent]

what about that whole big black part with the light switches, kill switch and starter button? Can i just take all of that off and put a starter button somewhere else?
james

[4wheelboy]

most people use a dirt bike kill switch but i dont know how they wire that in:confused: