anyone with a fibe 250R hood

[daiglea]

I got this hood and the mounting system underneath shown in the picture realy dosent work good at all. How did you guys mount yours to your fenders.http://www.imagestation.com/picture/sraid107/p6c18bd6852f21d0ff41cbadcc19c638b/f9608ffd.jpg

[daiglea]

top

[JDiablo]

http://www.exriders.com/vbb/showthread.php?s=&threadid=89434 ;)

[gthunder440]

i have a 250r hood from fibe industries on my ex with the same mounting bolts, it had two near the back which hit the gas tank, i just removed those and used these things i think are called blind screws and nuts, for the other four i just taped the hood to my bike and used a sharpie and marked around the holes, i did not cut my plastic at all and it maybe sits about and 1/8" off the plastic, looks good, i used rubber washers on all the bolts to help keep it from cracking, so far so good

[nacs400ex]

Drill the four holes for the bottom section of the hood. But seeing how its a 250r hood, you are going to have to figure out your own monting system. Its not too hard, just a little thinking. I used two small bolts.