PhilMoore
04-02-2004, 08:24 PM
I got my JE 416 piston installed. I am also putting in a HotCams stage I.
The new JE piston has deeper valve cuts than the stock piston.
I don't have any clay on hand. I will probably go get some and check the clearance, unless somebody knows if there is PLENTY 'O ROOM with this setup.
Thanks,
Phil
BTW; Uh, um, ah, does the 416 require a new sleeve? I thought it was just a bore to get to 416?
The new JE piston has deeper valve cuts than the stock piston.
I don't have any clay on hand. I will probably go get some and check the clearance, unless somebody knows if there is PLENTY 'O ROOM with this setup.
Thanks,
Phil
BTW; Uh, um, ah, does the 416 require a new sleeve? I thought it was just a bore to get to 416?