|
Roll Design's
Beau Baron Takes Second at Cahuilla Creek MX
WORCS
ATV Racing – Round 4 – Anza, CA –
April 24, 2011
 |
| Roll
Design's Beau Baron placed second at WORCS
round 4. Baron now sits third in the points
race in the ATV Pro Class |
Fallbrook, CA (5/10/2011) - Beau
Baron puts on a last lap charge to get around Jeremie
Warnia, and take his place on the podium.
Round #4 of the 2011 WORCS ATV series was held
at Cahuilla Creek MX in Anza California. Once
again Mother Nature threw a curve ball at the
racers with wind and cold temperatures for a spring
event. Cahuilla Creek MX sits at about 4100ft
above sea level in the Cahuilla mountain range.
The MX gate was back so it wasn’t a dead
engine start for this round. Dustin Nelson a multi-time
Quad X champion would be the first to the corner
on his Roll Design/Elka/Yamaha YFZ450R. Can-Am’s
Jeremie Warnia and Josh Frederick would pass Nelson
in the first few laps, who was holding a strong
3nd Place, before having electrical issues ended
his run back to the front. Beau Baron would assume
the 3rd Spot, where for most of the race the top
two would be switching places.
With a last lap charge Baron closed the gap to
2nd where Warnia would make a big mistake in the
off-road section, allowing Baron to make his move
and grab the second place podium spot. With no
time left to hunt down Frederick, Baron would
settle in and cruise in to ensure a spot on the
podium that had eluded him so far this season.
In the Pro Am class, Garrin Fuller #45 of Duncan
Racing, and his Roll Design / Elka suspended TRX450
would be back after an elbow injury. Fuller came
out strong and put the hammer down with the fastest
lap time of 10:46.243 to take home the 1st Place
spot, followed by Collins Webster and Roll Design
/ Elka equipped Keith Johnson in 3rd. Johnson
was awarded the “Hard Charger” award
after a crash on about the 3rd lap put him way
back in the pack, yet still managing to fight
back and claim the podium spot.
Keith Johnson also took the Open A class win
on Saturday, racing his younger brother Casey’s
KFX450R quad in tribute fashion. Casey passed
away last year, and the victory was for him, and
a win that will surely be remembered.
In the women’s A class, Julie Russell aboard
her TRX450R MCR/Roll Design/ Elka Honda would
get off the gate in the second spot and getting
the lead early. Checking out from the class during
the second lap and being the fastest lap of the
race 10:50.630 would take home the 1st Place trophy
as well. Be sure to watch “A Lap With”
starring Julie Russell as she made her run to
victory.
Check out some of the latest race photos at www.rolldesign.com
on the main page banner.
About Roll Design
Roll Design manufacturers
high-end suspension and handling components for
ATV’s. Doug Roll started the company in
1988 with the idea to build the best ATV off-road
racing suspensions on the market. After 22 years,
Roll Design control arms and steering shafts have
won more off-road races, in the toughest conditions
such as the Baja and Dakar than any other ATV
suspension manufacturer in existence. Roll Design
products are 100% made in the USA in Fallbrook,
CA with the highest quality standards and components
available in the industry. Roll Design is also
a USA Factory Authorized Service Center for Elka
Suspension. You can lean more about Roll Design
at www.rolldesign.com
& www.elkaservicecenter.com
www.rolldesign.com
Discuss
this in ATVriders.com Forum
| 
